Replacing A 3.5-Inch Backplane; Preliminary Steps; Removing The 3.5-Inch Hdd Bay Top Cover - Fujitsu PRIMERGY TX1330 M4 Upgrade And Maintenance Manual

7.3.10 Replacing a 3.5-inch backplane

Field Replaceable Unit
(FRU)
Tools: Phillips PH2 / (+) No. 2 screw driver

7.3.10.1 Preliminary steps

"Locating the defective server" on page 51
Ê
"Shutting down the server" on page 53
Ê
"Disconnecting the power cord" on page 54
Ê
"Getting access to the component" on page 55
Ê
Ê If applicable, "Removing the bay covers" on page 64
Ê Release all HDD/SSD modules and pull them out a few centimeters, see
section "Removing 3.5-inch HDD modules" on page 178
V
The HDD modules need not to be removed completely. But if you
want to remove them nevertheless, check if all HDD modules are
uniquely identified so that you can reinsert them into their original
bays.
Ê Release all dummy modules and pull them out a few centimeters, see
section "Removing a 3.5-inch HDD dummy module" on page 176
Ê Disconnect all cables from the defective SAS backplane.

7.3.10.2 Removing the 3.5-inch HDD bay top cover

I
The 3.5-inch HDD front cover does not need to be removed in order to
replace a 3.5-inch HDD SAS backplane. In the figures, the front cover
has been removed for illustration purposes only.
TX1330 M4
Hard disk drives (HDD) / solid state drives (SSD)
Upgrade and Maintenance Manual
Hardware:15 minutes
183