Acoustic Indicators - Fujitsu PRIMERGY TX1330 M4 Upgrade And Maintenance Manual

17.2.4 Acoustic indicators

PEI Beep Codes
Pre-EFI Initialization (PEI) - memory Initialization (bootblock)
# of Description
Beep
1 Memory not installed
2 Recovery started
4 Recovery failed
DXE Beep Codes
Driver Execution Environment (DXE) - main hardware Initialization (POST)
# of Description
Beep
1 Invalid password
5 No Console Input
1
devices
2
devices
TX1330 M4
Action
Ê Check if the memory module is installed.
Ê Check if the memory module is installed
Recovery procedure is initialized by jumper
settings on the system board and announced
with two beep.
This is only an information.
Ê Restart the recovery procedure again.
Ê If the same beep code sounds again,
Action
Ê Check for the correct password and try
Booting will continue.
or Output
1
Serial console redirection is considered a
are found
console output device if enabled.
2
Serial console redirection is considered a
console input device if enabled.
This beep code is only an information.
Upgrade and Maintenance Manual
correctly.
replace the system board.
again.
Make sure that the caps lock key is
deactivated.
Appendix A
471