Before You Start - Fujitsu PRIMERGY TX1330 M4 Upgrade And Maintenance Manual

2

Before you start

Before you start any upgrade or maintenance task, proceed as follows:
Ê Carefully read the safety instructions in chapter
page 37.
Ê Make sure that all necessary manuals are available, see the documentation
overview in section
PDF files if required.
Ê Make yourself familiar with the procedure categories introduced in section
"Classification of procedures" on page
Ê Ensure that all required tools are available according to section
need at hand" on page
Advanced Thermal Design (ATD)
The ATD option allows you to operate the system with a wider temperature
range either of 5 °C to 40 °C or 5 °C to 45 °C, depending on your system and
configuration.
V
CAUTION
In a system that is configured with ATD, only certain components which
support the respectively increased higher operating temperature range
may be installed and used. For applicable restrictions, see the official
configurator tool.
Installing optional components
The operating manual of your server gives an introduction to server features
and provides an overview of available hardware options.
Use the Fujitsu ServerView Suite management software and the iRMC web
interface to prepare hardware expansions. ServerView Suite documentation is
available online at http://manuals.ts.fujitsu.com.
For Japan:
http://www.fujitsu.com/jp/products/computing/servers/primergy/manual/
TX1330 M4
"Documents you need at hand" on page
33.
This option can only be ordered from the
manufacturer and is indicated by the respective
logo on the identification rating plate.
Upgrade and Maintenance Manual
"Important information" on
29.
33. Print the
"Tools you
27