Replacing The Microsd Card; Concluding Steps - Fujitsu PRIMERGY TX1330 M4 Upgrade And Maintenance Manual

System board and components
Ê Remove the system fan module, see section
module" on page 81

14.6.4.2 Replacing the microSD card

Ê Remove the Dual microSD 64GB Enterprise, see section
Dual microSD 64GB Enterprise" on page
Ê Remove the defective microSD card from the Dual microSD 64GB
Enterprise. Proceed as described in the following:
Ê To eject the defective microSD card, gently push it in and then let go (see
figure 294).
Ê Pull the microSD card straight out of its slot.
V
CAUTION!
The microSD card contains customer information. After replacing the
microSD card, hand the defective card over to the customer. If the
customer requests disposal of the defective microSD card, proceed
as follows:
Ê Using a pair of side-cutting pliers, cut the microSD card in half.
Ê Install the new microSD card on the Dual microSD 64GB Enterprise.
Proceed as described in the following:
Ê With the label facing up, insert the microSD card into the microSD slot on
the controller until it locks in place (see figure 295).
Ê Install the Dual microSD 64GB Enterprise, see section
microSD 64GB Enterprise" on page

14.6.4.3 Concluding steps

Ê Install the system fan module, see section
on page 83
"Reassembling" on page 67
Ê
"Connecting the power cord" on page 78
Ê
"Switching on the server" on page 80
Ê
416 Upgrade and Maintenance Manual
"Removing the system fan
412.
410.
"Installing the system fan module"
"Removing the
"Installing the Dual
TX1330 M4