Fujitsu PRIMERGY TX1330 M4 Upgrade And Maintenance Manual page 429

Figure 301: Removing the right side cover (B)
Ê Slide the right side cover towards the server rear as far as it will go (1).
Ê Remove the three hooks on the right side cover from the slots on the upper
chassis edge:
Ê Using a slotted screw driver, slightly pry up on the middle hook until it
disengages (2).
Ê Pull up on both ends of the right side cover to remove the left and right
hooks from the slots on the upper chassis edge.
Ê Ensure that all cables and components are properly secured inside the
server and that there are no loose pieces.
Ê Carefully turn the server upside down.
I
At least two people are needed to turn over a fully equipped server.
Remove HDDs and hot-plug PSUs in order to facilitate the task.
Ê Lift off and remove the right side cover.
I
The right side cover is no longer required.
Ê Leave the server in its upside down position.
TX1330 M4
Converting a floorstand model to a rack model
Upgrade and Maintenance Manual 429