Connecting The Power Cord - Fujitsu PRIMERGY TX1330 M4 Upgrade And Maintenance Manual

Basic hardware procedures
4.6

Connecting the power cord

V
CAUTION!
The server supports a mains voltage in the range of 100 V - 240 V. You
may only operate the server if its rated voltage range corresponds to the
local mains voltage.
Standard power supply
Ê Connect the power cord to the PSU.
Ê If applicable, connect the mains plug to a grounded mains outlet in the in-
house power supply network.
Figure 35: Securing power cord
Ê Thread the cable tie through the eye (1).
Ê Pull the cable tie tight to secure the power cord (2).
The insulated connector cannot now be disconnected from the server
accidentally.
You can loosen the cable tie by opening the small locking lever (2).
I
It will take about 60 seconds until the server can be powered on.
78 Upgrade and Maintenance Manual
TX1330 M4