Installing The New System Board - Fujitsu PRIMERGY TX1330 M4 Upgrade And Maintenance Manual

System board and components
Figure 298: Removing the power cable clamp
Ê Using a small pair of combination pliers, press together the hooks on the
power cable clamp (1) and remove it from the defective system board (2).

14.7.1.3 Installing the new system board

Ê If applicable, install the iRMC microSD card, see section
microSD card" on page
Ê If applicable, install the TPM, see section
Ê Check the settings on the new system board (see section
settings" on page
Ê Insert the system board by holding it at a slight angle. Slide the connectors
into the I/O panel (see figure 297).
Ê Lower the system board carefully into the chassis.
Ê Adjust the system board. If necessary adjust the position of the system
board with a gentle twisting motion (orange circles in figure
centering bolts).
Ê Fasten the system board with the eight screws (see figure 296).
422
397.
473).
Upgrade and Maintenance Manual
"Installing the iRMC
"Installing the TPM" on page
"Onboard
388.
296 show the
TX1330 M4