Installing An Expansion Card - Fujitsu PRIMERGY TX1330 M4 Upgrade And Maintenance Manual

9.4.1.3

Installing an expansion card

I
If an optional FBU will be installed in the system, install a TFM on the
RAID controller, before proceeding.
Ê Remove the expansion card from its protective packaging.
I
For further instructions regarding controller settings, see the
accompanying documentation.
Ê If applicable, attach the required slot bracket to the expansion card, see
section "Installing a slot bracket" on page
Ê If applicable, connect internal cables to the expansion card.
I
For the cable plan, see chapter
Figure 191: Installing the expansion card
Ê Carefully insert the expansion card into the desired PCI slot and press down
firmly until it is fully seated in the slot (1).
Ê Clip on the slot cover clamp (2).
Ê Fold down the locking handle on the slot cover clamp until it locks in place
(3).
Ê If applicable, connect a FBU to the expansion card, see section
an FBU" on page
TX1330 M4
299.
Upgrade and Maintenance Manual
Expansion cards and backup units
271.
"Appendix B" on page 477.
"Installing
281