Fujitsu PRIMERGY TX1330 M4 Upgrade And Maintenance Manual page 447

Figure 321: Connecting the intrusion switch cable
Ê Run the intrusion switch cable through the cable clamps and the cable guide
(see arrows).
Ê Connect the intrusion switch cable to the system board (see circle).
V
CAUTION!
Please make sure that the intrusion switch cable is connected to the right
connector "INTR" on the system board, see section
connectors" on page
Please do not connect the intrusion switch cable to the connector "FAN2"
near the "INTR".The system may occur "Sudden Power Down" and
"system board defect", if the intrusion switch cable is connected to
"FAN2".
TX1330 M4
455.
Upgrade and Maintenance Manual
Cabling
"Onboard
447