Fujitsu PRIMERGY TX1330 M4 Upgrade And Maintenance Manual page 158

Power supply unit (PSU)
Figure 83: Connecting cables to the system board
Ê Connect the cables to the system board:
1 PSU power cable to connector "PWR MAIN".
2 PSU signal cable to connector "P30".
Ê Run the cables through the corresponding cable clamps (see circles).
Ê Connect the power cables to the corresponding accessible drives /
backplanes.
I
For the cable plan, see chapter
Installing hot-plug PSU and dummy cover
Ê Install the hot-plug PSU, see section
page 137.
I
The PSU must be installed in the first bay. The dummy cover must be
installed in the second bay.
Ê Install the dummy cover, see section
page 142.
158 Upgrade and Maintenance Manual
"Appendix B" on page
"Installing a hot-plug PSU" on
"Installing a dummy cover" on
477.
TX1330 M4