Preliminary Steps; Removing The Defective Hot-Plug Psu; Installing The New Hot-Plug Psu; Concluding Steps - Fujitsu PRIMERGY TX1330 M4 Upgrade And Maintenance Manual

Power supply unit (PSU)
6.3.3.1

Preliminary steps

"Locating the defective server" on page 51
Ê
"Locating the defective component" on page 52
Ê
Ê Check which PSU is defective.
A PSU is defective when the PSU status indicator lights orange. For more
information, see section
Ê Only when replacing a PSU in a non-redundant configuration:
down the server" on page 53
Ê Remove the power cord from the defective PSU, see section
the power cord" on page 54
6.3.3.2

Removing the defective hot-plug PSU

Ê Remove the hot-plug PSU, see section
page 141.
6.3.3.3

Installing the new hot-plug PSU

Ê Install the hot-plug PSU, see section
page 137.
6.3.3.4

Concluding steps

Ê Connect the power cord to the new hot-plug PSU and secure it with a cable
tie, see section
Ê Only when replacing a hot-plug PSU in a non-redundant configuration:
"Switching on the server" on page 80
"Performing a fan test" on page 124
Ê
144
"Indicator on hot-plug PSU" on page
"Connecting the power cord" on page
Upgrade and Maintenance Manual
"Removing a hot-plug PSU" on
"Installing a hot-plug PSU" on
78.
469.
"Shutting
"Disconnecting
TX1330 M4