Preliminary Steps; Removing The Defective 2.5-Inch Hdd/Ssd Module; Installing The New 2.5-Inch Hdd/Ssd Module; Concluding Steps - Fujitsu PRIMERGY TX1330 M4 Upgrade And Maintenance Manual

7.4.8.1

Preliminary steps

"Locating the defective server" on page 51
Ê
Ê If applicable, "Getting access to the component" on page
"Locating the defective component" on page 52
Ê
7.4.8.2

Removing the defective 2.5-inch HDD/SSD module

Ê Remove the HDD/SSD module, see section
HDD/SSD module" on page
Ê If applicable, remove the HDD/SSD from the installation frame, see section
"Handling HDDs or SSDs without installation frame" on page
7.4.8.3

Installing the new 2.5-inch HDD/SSD module

Ê If applicable, install the HDD/SSD in the installation frame, see section
"Handling HDDs or SSDs without installation frame" on page
Ê Install the HDD/SSD module, see section
modules" on page
7.4.8.4

Concluding steps

Ê If the HDD/SSD is configured using a RAID controller with a RAID level
higher than "0", the rebuild will start automatically, see
RAID array rebuild" on page
Ê If applicable, "Reassembling" on page 67
TX1330 M4
Hard disk drives (HDD) / solid state drives (SSD)
208.
205.
117.
Upgrade and Maintenance Manual
55.
"Removing a 2.5-inch
"Installing 2.5-inch HDD/SSD
section"Performing a
164.
164.
211