Fujitsu PRIMERGY TX1330 M4 Upgrade And Maintenance Manual page 39

Always connect the server and the attached peripheral devices to the same
●
power circuit. Otherwise you run the risk of losing data if, for example, the
server is still running but a peripheral device (e.g. memory subsystem) fails
during a power outage.
The adequately shielded data cables must be used.
●
All data and signal cables must have sufficient shielding. The use of cable
type S/FTP Cat5 or higher is recommended.
Use of unshielded or badly shielded cables may lead to increased emission
of interference and/or reduced fault-tolerance of the device.
Ethernet cabling has to comply with EN 50173 and EN 50174-1/2 standards
●
or ISO/IEC 11801 standard respectively. The minimum requirement is a
Category 5 shielded cable for 10/100 Ethernet, or a Category 5e cable for
Gigabit Ethernet.
Route the cables in such a way that they do not create a potential hazard
●
(ensure that no-one can trip over them) and that they cannot be damaged.
When connecting the server, see the relevant instructions in this manual.
Never connect or disconnect data transmission lines during a storm (risk of
●
lightning hazard).
Ensure that no objects (e.g. jewelry, paperclips etc.) or liquids can get inside
●
the server (risk of electric shock, short circuit).
In emergencies (e.g. damaged casing, controls or cables, penetration of
●
liquids or foreign bodies), contact the server administrator or your customer
service team. Only disconnect the server from the mains power supply if
there is no risk of harming yourself.
Proper operation of the server (in accordance with IEC 60950-1 resp.
●
EN 60950-1) is only ensured if the server is completely assembled and the
rear covers for the installation slots have been fitted (electric shock, cooling,
fire protection, interference suppression).
Only install server expansions that satisfy the requirements and rules
●
governing safety and electromagnetic compatibility and those relating to
telecommunication terminals. If you install other expansions, they may
damage the server or violate the safety regulations. Information on which
server expansions are approved for installation can be obtained from our
customer service center or your sales outlet.
The components marked with a warning notice (e.g. lightning symbol) may
●
only be opened, removed or exchanged by authorized, qualified personnel.
Exception: CSS components can be replaced.
TX1330 M4
Upgrade and Maintenance Manual
Important information
39