Preliminary Steps; Removing A Hot-Plug Psu - Fujitsu PRIMERGY TX1330 M4 Upgrade And Maintenance Manual

6.3.2.1

Preliminary steps

Ê Only when replacing a PSU in a non-redundant configuration:
down the server" on page
Ê Remove the power cord from the hot-plug PSU, see section
the power cord" on page
6.3.2.2

Removing a hot-plug PSU

Figure 73: Removing the PSU
Ê Push the handle of the PSU halfway upward in the direction of the arrow (1).
Ê Press in on the green locking latch (2).
Ê While keeping the green locking latch pressed, pull the PSU out of its bay
(3).
V
CAUTION!
Never leave the bay for the hot-plug PSU empty for more than two
minutes during operation. Otherwise, excessive temperatures could
damage system components.
TX1330 M4
53.
54.
Upgrade and Maintenance Manual
Power supply unit (PSU)
"Shutting
"Disconnecting
141