Removing The Heat Sink - Fujitsu PRIMERGY TX1330 M4 Upgrade And Maintenance Manual

"Disconnecting the power cord" on page 54
Ê
"Getting access to the component" on page 55
Ê
Ê Remove the system fan module, see section
module" on page 81

11.2.2 Removing the heat sink

Figure 217: Removing the heat sink
Ê Loosen the four captive screws on the heat sink in a crossover pattern (1-4).
Ê Carefully twist the heat sink back and forth to detach it from the CPU.
I
This may be necessary due to the adhesive quality of the thermal
paste located between the heat sink and CPU.
V
CAUTION!
Pay special attention not to damage any system board components
surrounding the CPU socket.
Ê Lift the heat sink out of the chassis.
TX1330 M4
Upgrade and Maintenance Manual
Processor (CPU)
"Removing the system fan
321