5. Use a #2 Phillips™ to remove the 2 screws from the AC
receptacle (Figure 2-11).
6. Pull the skin forward and out.
7. Reverse the above steps to reinstall.
2.5.12 INTAKE DUCT
(5 minutes)
1. Remove top lid. Refer to
2. Use a #2 Phillips™ to remove the 6 screws securing the
high security cover, unlock the high security access lock,
lift the lid and slide out (Figure 2-12).
F
IGURE
3. Use a #2 Phillips™ to remove the 3 screws from the corners of the intact duct (Figure 2-13).
4. Remove the duct by pulling it up and out.
CP2000-M/MR Service Booklet
020-100220-02 Rev. 1 (07/08)
2.5.5 Top Lid, on page
2-12 R
S
EMOVE
ECURITY
F
IGURE
Section 5: Parts and Module Replacement
2-10.
C
OVER
2-13 R
D
EMOVE
UCT
F
2-11 AC R
IGURE
ECEPTACLE
2-15