Christie CP2000-M Service Booklet page 95

Section 7: Serial Communications
Table 4.1 Function Codes
EXAMPLES:
(LPM+GLOB 1) set lamp mode as LiteLOC™ for global
(LPM+C108 1) set lamp mode as LiteLOC™ for channel 101
(LPM?) get the current lamp mode
Lamp Power (LPP)
DESCRIPTION
Set lamp power to be used when in Constant Power Mode.
SUBCODE
Cxxx
GLOB
EXAMPLES:
(LPP+GLOB 4500) set lamp power to 4500 for global
(LLP+C108 4500) set lamp power to 4500 for channel 108
(LPP+C108 ?) get lamp power for channel 108
Lens Vertical Offset Position Adjustment (LVO)
DESCRIPTION
Adjust lens to specific vertical position.
SUBCODE
Cxxx
None
EXAMPLES:
(LVO 500) Move lens mount to position 500 at vertical axis
Measured Color (MCG)
DESCRIPTION
Select the Measured Color Gamut file. This file describes the native colorimetry for the projector as installed and
is required for accurate color processing in the cinema electronics. This control is per channel to allow for
different colorimetry for applications such as 3D.
SUBCODE
Cxxx
None
Temp
EXAMPLES:
(MCG+C108 "Nominal") Use file "Nominal" on channel
(MCG+C108?) get measured color file name on channel 108
(MCG?L) list all entries of measured color control
Channel_Name (NAM)
DESCRIPTION
Set the descriptive channel name for the specified channel.
4-14
DESCRIPTION OF USE
Replace xxx with the channel number. Valid Range is 101 - 164.
Set lamp power for all channels when PPB is OFF.
DESCRIPTION OF USE
Replace xxx with the channel number. Valid Range is 101 - 164.
Moving lens mount to a specified vertical position.
Default data range -2200 to 2200.
DESCRIPTION OF USE
Replace xxx with the channel number. Valid Range is 101 - 164.
Select measured color gamut for the current channel.
Select measured color file as DLP active file, do not change
channel settings.
CP2000-M/MR Service Booklet
020-100220-02 Rev. 1 (07/08)