Christie CP2000-M Service Booklet page 100

Table 4.1 Function Codes
EXAMPLES:
(PPB 0) Don't use Power Per Button for current channel, use global settings instead
(PPB+C108 1) Use Power Per Button for channel 108
(PPB+C108?) Get Power Per Button state for channel 108
(PPB?) Get Power Per Button state for current channel
Processing Mode (PRM)
DESCRIPTION
Select whether to use cinema processing mode. Cinema processing mode. Cinema processing uses extended
image pixel depth and color processing algorithms. Alternative content is not intended to use cinema processing.
0 - do not use Cinema Processing.
SUBCODE
Cxxx
None
EXAMPLES:
(PRM+C108 1) Use cinema processing mode on channel 108
(PRM+C108 0) Do not use cinema processing mode on channel 108
(PRM?) Get current processing mode
Power (PWR)
DESCRIPTION
Change the power state of the projector. Data can be:
3 - Power OFF - all electronics power off except Projector Control Module (PCM). It's also called standby mode
1 - Power ON projector is powered on with lamp) ON
0 - FULL POWER mode - projector is ready for lamp ON
11 - Warm up. Read only, it's middle status between STANDY and FULL POWER mode
10 - Cool down. Read only, projector will stay in COOLING DOWN mode for 15 minutes after lamp is turned
OFF.
SUBCODE
None
STAT
EXAMPLES:
(PWR+STAT?) - Get projector power status
(PWR3) - Set the projector to
(PWR0) - Turn the projector
(PWR1) - Turn the projector
(PWR?) - Get the last command sent to projector
CP2000-M/MR Service Booklet
020-100220-02 Rev. 1 (07/08)
DESCRIPTION OF USE
Replace xxx with channel number. Valid Range is 101 - 164.
Select processing mode for the current channel.
DESCRIPTION OF USE
Select power state.
Read only status of current power state.
STANDBY
mode
ON OFF
and lamp
ON ON
and lamp
Section 7: Serial Communications
4-19