2.5
EXTERNALS AND CONSUMABLES
Never operate the projector or the fans without all the covers installed.
2.5.1 LENS
The lens is held in place by 2 hex screws (optional), 3 magnets and a locking clamp.
(2 minutes)
1. Position the lens clamp OPEN to unlock the
lens from the mount. If necessary, remove
the 2 hex screws from the mounts (Figure
2-1).
2. Pull the lens out of the lens mount.
3. Reverse the above steps to reinstall.
NOTE: Use of the optional hex screws is
required if the projector is ceiling mounted
where it is possible the lens could become
loose from constant vibrations and cause
physical injury.
CP2000-M/MR Service Booklet
020-100220-02 Rev. 1 (07/08)
Section 5: Parts and Module Replacement
WARNING
F
IGURE
2-1 R
L
EMOVE
ENS
2-7