Christie CP2000-M Service Booklet page 49

18. Disconnect the lamp exhaust thermal harness (Figure 2-44, B).
19. Use a #2 Phillips™ to remove 3 screws securing the lamp exhaust duct (Figure 2-44, A&C).
F
IGURE
20. Use a long angled #2 Phillips™ screwdriver to remove the 2 screws securing the LVPS to the
housing (Figure 2-45, A).
21. Remove the PEM nut on the LVPS casing (Figure 2-36, B).
F
IGURE
22. Use a #2 Phillips™ to remove the 2 screws securing the lamp exhaust harness.
CP2000-M/MR Service Booklet
020-100220-02 Rev. 1 (07/08)
2-44 R L E
EMOVE AMP XHAUST
2-45 R S
EMOVE CREWS
Section 5: Parts and Module Replacement
A
Screw Securing Lamp Exhaust Duct
B
Lamp Exhaust Harness
C
Screw Securing Lamp Exhaust Duct
A
B
F LVPS
ROM
LVPS Screws
PEM Nut
2-39