Christie CP2000-M Service Booklet page 107

Section 7: Serial Communications
Table 4.1 Function Codes
SUBCODE
Cxxx
None
EXAMPLES:
(TIR?L) list all entries on Input Reference control
(TIR+C101 1) set Input Reference to 1 on channel 101
(TIR+C101?) get Input Reference on channel 101
Time/Date (TMD)
DESCRIPTION
Set the time zone.
SUBCODE
DATE
TIME
ZONE
EXAMPLES:
(TMD+ZONE 20) Set time zone to EST
(TMD+TIME "17:50:45") Set new local time
(TMD+DATE "2007/02/30") Set the local date.
(TMD+TIME?) Get local time (TMD+TIME! 17:50:45)
Output Reference GPO (TOO)
DESCRIPTION
Setup Display Reference GPO for 3D control. This signal selects the output signal that will be used as a reference
to the gating technology so that the images can be targeted to the correct eyes.
SUBCODE
Cxxx
None
EXAMPLES:
(TOO?L) list all entries on Output Reference GPO control
(TOO+C101 1) set Output Reference GPO to 1 on channel 101
(TOO+C101?) get Output Reference GPO on channel 101
Output Reference Polarity (TOP)
DESCRIPTION
Setup Output timing signal reference polarity for 3D control
SUBCODE
Cxxx
None
4-26
DESCRIPTION OF USE
Replace xxx with the channel number. Valid Range is 101 - 164.
Select input reference for the current channel.
DESCRIPTION OF USE
Set the date in the form yyyy/mm/dd.
Set the local time in the form hh:mm:ss.
Set the time zone.
DESCRIPTION OF USE
Replace xxx with the channel number. Valid Range is 101 - 164.
Select GPO for the current channel.
DESCRIPTION OF USE
Replace xxx with the channel number. Valid Range is 101 - 164.
Select output reference polarity for the current channel.
CP2000-M/MR Service Booklet
020-100220-02 Rev. 1 (07/08)