5.5.13 Intake Duct
(Estimated Replacement Time: 10 minutes)
1. Remove the top lid. Refer to
2. Remove the high security lid. Refer to
3. Use a #1 Phillips
4. Remove the duct by pulling it up and out.
5. Reverse the above steps to install. NOTE: When reinstalling, tilt the duct on an angle to clear the flange
(Figure 5-14).
CP2210 Service Manual
020-100556-04 Rev. 1 (01-2012)
5.5.5 Top Lid, on page
5.5.6 High Security Lid, on page
to remove the two screws from the corners of the intact duct (Figure 5-13).
™
Figure 5-13 Intake Duct
Figure 5-14 Reinstalling Intake Duct
Section 5: Parts and Module Replacement
5-7.
5-7.
5-11