Christie CP2000-M Service Booklet page 94

Table 4.1 Function Codes
EXAMPLES:
(LPH?) get usage in hours
(LPH+FLSK?) get lamp strikes
Lamp Intensity (LPI)
DESCRIPTION
Set lamp intensity set point. The value is used when lamp mode is set to LiteLOC™. The projector will adjust the
Lamp Power to maintain this intensity.
SUBCODE
Cxxx
GLOB
EXAMPLES:
(LPI+GLOB 4500) set lamp intensity to 4500 for global
(LPI+C108 4500) set lamp intensity to 4500 for channel 108
(LPI+C108?) get lamp intensity for channel 108
Lamp Life (LPL)
DESCRIPTION
Set or get expected lamp life in hours. The default hours will be used if lamp life is 'not set'. Lamp expiry
message will be sent out when lamp usage is over the lamp life.
SUBCODE
LIFE
None
ROTA
ROTW
EXAMPLES:
(LPL+LIFE 0) disable lamp expired message
(LPL+ROTW 1) enable lamp rotation message
((LPL 1500) set lamp life limit to 1500 hours
Lamp Mode (LPM)
DESCRIPTION
Set lamp mode to constant power or LiteLOC™ for global and per channel.
SUBCODE
Cxxx
GLOB
CP2000-M/MR Service Booklet
020-100220-02 Rev. 1 (07/08)
DESCRIPTION OF USE
Replace xxx with the channel number. Valid Range is 101 - 164.
Set lamp intensity for all channels when PPB is OFF.
DESCRIPTION OF USE
0 - No warning will be generated. 1 - Lamp Life Expiry Warning
will be generated when lamp hours extends past lamp life.
Warning will be reported in SST. Warning will be cleared by
extending lamp life or changing the lamp.
Set or get expected lamp life.
Set to 1 acknowledge the Lamp Rotation Warning. Will auto clear
at lamp life or on lamp change.
0 - No warning will be generated. 1 - Lamp Rotation Warning will
be generated when lamp hours extents past 1/2 lamp life. Warning
will be reported in SST. Warning will be cleared by LPL+ROTA or
changing the lamp.
DESCRIPTION OF USE
Replace xxx with the channel number. Valid Range is 101 - 164.
Set lamp mode for global. The value is used when PPB is 0.
Section 7: Serial Communications
4-13