Christie CP2000-M Service Booklet page 36

Section 5: Parts and Module Replacement
6. Disconnect the Ballast Communications
harness by removing the 2 retaining screws
and pulling up (Figure 2-28).
7. Use a #3 Phillips™ to remove the 5 captive
screws securing the ballast to the housing.
Three screws are located along the front edge
of the ballast (Figure 2-29), another in the
back-left corner and the front-right corner.
NOTE: To access the screws on the left-side
close the lamp access door.
8. Lift the front end of the ballast up and out,
being careful not to catch anything as it is
removed.
9. Reverse the above steps to reinstall the lamp
ballast.
10. Perform LampLOC™ adjustment. Refer to
the CP2000-M/MR User Manual
(020-100123-xx).
2-26
F 2-28 B C
IGURE ALLAST OMMUNICATION
F 2-29 R
IGURE
CP2000-M/MR Service Booklet
H
ARNESS
B
EMOVE ALLAST
020-100220-02 Rev. 1 (07/08)