Section 5: Parts and Module Replacement
7. Remove the 2 (3mm hex) rotational
integrator adjustment screws (Figure 2-
57).
8. Slide the integrator rod back and tilt to
remove from the casing.
9. Reverse the above steps to install. Ensure
the integrator rod lines up with the slots in
the casing (Figure 2-58).
10. Power up the projector and adjust the
integrator/fold mirror for proper aperture
alignment. For details, refer to the
CP2000-M/MR User Manual (020-
100123-xx).
2-48
F
2-57 R
A
IGURE
EMOVE
DJUSTMENT
F
2-58 A
I
IGURE
LIGN
NTEGRATOR
CP2000-M/MR Service Booklet
S
CREWS
R
OD
020-100220-02 Rev. 1 (07/08)