Christie CP2000-M Service Booklet page 83

Section 7: Serial Communications
Table 4.1 Function Codes
Address (ADR)
DESCRIPTION
Set/Query Device Address on ASCII Protocol network. Required only for RS - 232 connections that are daisy
chained to allow directed messages.
SUBCODE
None
EXAMPLES:
(0 ADR 5) Set first device with an address of 0 to 5
(65535 ADR 0) Set all devices to address 0
(65535 1001ADR ?) Query address for all devices and return results to address 1001
Expected response to previous query (01001 00005ADR!005)
Auxiliary Motorized Lens (AML)
DESCRIPTION
Control the motorized auxiliary lens (anamorphic or converter lens).
SUBCODE
CALI
CSTA
Cxxx
INST
LENI
LENO
NONE
POSI
EXAMPLES:
(AML?) get the current status of auxiliary lens
(AML+C108 1) Use auxiliary lens on channel 108
(AML+C108?) Query auxiliary lens setting for channel 108
(AML+C108!001) response form previous query
(AML+INST 1) set flag for using MALM, otherwise MALM is ignored
(AML+LENI 1000) move lens to step 1000 for lens in position
(AML+LENO 7000) move lens to step 1000 for lens out position
(AML+POSI ?) query where the lens is
(AML+CSTA ?) query how much percent the MALM calibration is running
4-2
DESCRIPTION OF USE
Valid Address range is 0 to 999. Reserved broadcast address is
65535.
DESCRIPTION OF USE
1, Send command to find the center position of the sensor for
MALM.
0-100%, read only command for returning the status of MALM
calibration.
Replace xxx with the channel number. Range from 101 - 164.
0-1, the flag to indicate if MALM is installed.
steps, The steps to move MALM to lens in position where (AML1)
is set.
steps, The steps to move MALM to lens out position where
(AML0) is set.
Set auxiliary lens position 0 - lens removed from optical path 1 -
lens inserted in optical path.
Read only command which returns where MALM is located.
CP2000-M/MR Service Booklet
020-100220-02 Rev. 1 (07/08)