2.3
SAFETY WARNINGS AND GUIDELINES
Always power down and disconnect power sources prior to servicing.
All module replacement procedures must be performed by qualified service technicians.
NON-INSULATED DANGEROUS VOLTAGES MAY BE EXPOSED
Use a grounded wrist strap when handling electronic assemblies.
Once the projector is powered down, allow the cooling fans to automatically turn OFF
before disconnecting from AC and opening the projector. This takes approximately 15
minutes.
CP2000-M/MR Service Booklet
020-100220-02 Rev. 1 (07/08)
WARNINGS
HIGH VOLTAGES MAY BE EXPOSED
Always unplug the projector prior to disassembly.
QUALIFIED SERVICE TECHNICIANS REQUIRED
Always disconnect from AC prior to disassembly.
OBSERVE ALL ELECTROSTATIC PRECAUTIONS
ALLOW LAMP AND PROJECTOR TO COOL DOWN
Section 5: Parts and Module Replacement
2-5