Section 5: Parts and Module Replacement
23. Use a #2 Phillips™ screwdriver to remove the 2 screws securing the liquid cooling air filter.
24. Loosen the thumbscrew on the liquid cooling air filter. Tilt the entire unit forward and pull out
slightly. For details, refer to
25. As you pull the LVPS unit out of the LVPS compartment, ensure the harnesses do not get caught.
Feed the harnesses through the other side before pulling the module out.
26. Use a #2 Phillips™ screwdriver to remove the 4 screws from the LVPS cover (Figure 2-46, B).
27. Remove the harnesses and transfer to the replacement LVPS (Figure 2-46, A&C).
28. Reverse the above steps to install.
F
IGURE
2-40
2.5.13 Liquid Cooling Air Filter, on page
2-46 LVPS C
OVER AND
A
Harnesses (Remove)
B
2 of 4 Screws
C
Harnesses (Remove)
H
ARNESSES
2-17.
CP2000-M/MR Service Booklet
020-100220-02 Rev. 1 (07/08)