Installing The Chiller Duct; Filling And Starting The Chiller - Christie CP4440-RGB Installation And Setup Manual

A Projector coolant inlet port
B Projector coolant outlet port
For detailed information on connecting the coolant lines and hose accessories, refer to the
Christie Chiller Setup Kit Instruction Sheet (P/N: 020-103145-XX).

Installing the chiller duct

Installing a chiller duct and exhaust conduit allows warm air generated by chiller to be removed from
the projection room.
1. Attach the duct over the exhaust fan on the top of the chiller unit.
The duct is available in the Christie Chiller Setup Kit Air Ducts (P/N: 163-150107-XX).
For detailed information on connecting the chiller duct, refer to the Christie Chiller Setup Kit
Instruction Sheet P/N: 020-103145-XX.
2. If required, a reducer duct is also provided in the kit and can be installed over the base duct to
accommodate smaller diameter exhaust conduits.
3. Once installed, connect the duct into the exhaust conduit to vent the heated air outside of the
projection room.

Filling and starting the chiller

Ensure the coolant lines are connected to the projector and all connections are tightened.
1. Open the chiller reservoir fill cap.
CP4440-RGB and CP4450-RGB Installation and Setup Guide
020-103072-05 Rev. 1 (01-2023)
Copyright © 2023 Christie Digital Systems USA, Inc. All rights reserved.
If printed, please recycle this document after use.
Installing and setting up
41