Fold Mirror 1 - Christie CP2000-M Service Booklet

2.8.7 FOLD MIRROR 1

Fold mirror 1 is accessed from the front left-corner of the projector. The alignment screws are
positioned along the top of the light tube, which allows them to be easily adjusted.
(40 minutes; includes 10 minute calibration)
1. Remove top lid. Refer to
2. Remove exhaust panel skin. Refer to
3. Remove contrast aperture. Refer to
4. Remove the light sensor module. Refer to
5. Loosen the 2.5mm locking hex screw and remove the 2 hex screws securing fold mirror 1 to the
bracket (Figure 2-63).
6. Reverse the above steps to install fold mirror 1. NOTE: When installing ensure the reflective
surface faces inwards (Figure 2-64).
7. Power up the projector and align the fold mirror. For details, refer to the CP2000-M/MR User
Manual (020-100123-xx).
CP2000-M/MR Service Booklet
020-100220-02 Rev. 1 (07/08)
Wear gloves when handling the fold mirror.
2.5.5 Top Lid, on page
2.8.4 Contrast Aperture, on page
F 2-63 F M
IGURE OLD IRROR
F 2-64 I
IGURE
Section 5: Parts and Module Replacement
CAUTION
2-10.
2.5.9 Exhaust Panel Skin, on page
2.8.5 Light Sensor Module, on page
A
2.5mm Locking Hex Screw
B
Hex Screw (1 of 2)
1
F M
NSTALLING OLD IRROR
2-13.
2-49.
2-49.
1
2-51