Christie CP2000-M Service Booklet page 101

Section 7: Serial Communications
Table 4.1 Function Codes
Table 4.2 Projector Power Modes
NOTES: 1) The green status LED flashes while the yellow LED is on steady while in "Boot Delay". 2) Both green and yellow status LEDs flash during "Cool
Down.
Remote Access Level (RAL)
DESCRIPTION
Set the remote serial protocol access level for a serial communications port. Note: Valid sections are 0 - No
Access, 1 - Login Required, 2 - Free Access.
SUBCODE
None
PRTA
EXAMPLES:
(RAL 0) Disable remote serial protocol access for all Ethernet ports
(RAL?) Get access level for Ethernet ports (RAL!0)
(RAL+PRTA 2) Set remote serial protocol access level on port A to free access
(RAL+PRTA?) Get access level (RAL+PRTA!2)
Screen Format (SCF)
DESCRIPTION
Select Screen format file which describes the geometry for the output image.
SUBCODE
Cxxx
FULL
None
EXAMPLES:
(SCF+C108 "FLAT") Use file "FLAT" on channel 108
(SCF+C108?) get screen file name on channel 108
(SCF?L) list all available entries of screen control
Shutter/Douser (SHU)
DESCRIPTION
Open/Close shutter/douser
4-20
DESCRIPTION OF USE
Set the access level on Ethernet all ports.
Set the access level on RS232 port A.
DESCRIPTION OF USE
Replace xxx with the channel number. Valid Range is 101 - 164.
Selects the full output screen.
Select screen file for the current channel.
CP2000-M/MR Service Booklet
020-100220-02 Rev. 1 (07/08)