Cold Mirror - Christie CP2000-M Service Booklet

Section 5: Parts and Module Replacement

2.8.6 COLD MIRROR

(50 minutes; includes 30 minute calibration)
1. Remove top lid. Refer to
2. Use a 2mm Allen™ key to loosen the bottom 2 hex screws (2mm) and remove the top 2 hex
screws and clips (Figure 2-61).
3. Grab the top corners of the mirror, pull up and out.
4. Reverse the above steps to install the cold mirror. NOTE: When installing ensure the reflective
surface faces inwards (Figure 2-62).
5. LampLOC™ and MCGD must be calibrated after installation. For details, refer to the CP2000-M/
MR User Manual (020-100123-xx).
2-50
CAUTION
Wear gloves when handling the cold mirror.
2.5.5 Top Lid, on page
F 2-61 L C
IGURE OOSEN OLD
F 2-62 I
IGURE NSTALLING
2-10.
M H S
IRROR EX CREWS
C M
OLD IRROR
CP2000-M/MR Service Booklet
020-100220-02 Rev. 1 (07/08)