2: Basic Operation; Safety Warnings And Guidelines; General Precautions; Ac/Power Precautions - Christie CP2000-SB Setup Manual

2 Basic Operation
2.1

Safety Warnings and Guidelines

This projector is designed for safe and reliable operation. However safe operation is not assured by
design alone; installers, service technicians, trained operators and all other users must maintain a safe
environment at all times. Please read through and understand all warnings and precautions before
attempting to operate the projector.

2.1.1 General Precautions

Be aware of the following general precautions in all CP2000-SB installations:
The extremely high brightness can cause permanent eye damage. 2) For pro-
tection from ultraviolet radiation, keep all projector housings intact during
operation. Protective clothing and safety goggles are recommended.
material away from the concentrated light beam of the lamp. 2) Position all
cables where they cannot contact hot surfaces or be pulled or tripped over.
NOTES: 1) The American Conference of Governmental Industrial Hygienists (ACGIH) recommends
occupational UV exposure for an 8-hour day to be less than 0.1 microwatts per square centimeters of
effective UV radiation. An evaluation of your workplace is advised to assure employees are not
exposed to cumulative radiation levels exceeding the government guidelines for your area. 2) Be
aware that some medications are known to increase one's sensitivity to UV radiation.
This projector must be installed on the floor only, and operated in an environment which meets the
operating range specifications. Refer to the CP2000-SB User Manual (020-100162-xx) for details.

2.1.2 AC/Power Precautions

Installation of this projector requires that an electrician hard-wire a 3-phase (Y) feed and a separate
15A single-phase feed from the pedestal toe to the AC supply in your building. You must also use only
the correct pedestal for your geographic area as stated in
Operate the projector at the specified voltage. Warning! Do not attempt operation if the AC supply
and pedestal are not within the specified voltage range.
Do not allow anything to rest on the power cord. Locate the projector where the cord cannot be abused
by persons walking on it or objects rolling over it. Never operate the projector if the power cable
appears damaged in any way. Do not overload power outlets and extension cords as this can result in
fire or shock hazards.
NOTE: Only qualified service technicians are permitted to open any enclosure on the product, and
only if AC has been fully disconnected at BOTH wall breakers. Warning! SHOCK HAZARD.
Disconnect from AC before opening any enclosure. Disconnect at BOTH wall breakers.
CP2000-SB Setup Guide
020-100249-02 Rev. 1 (05-2009)
1) Never look directly into the projector lens or at the lamp.
1) FIRE HAZARD. Keep hands, clothes, and all combustible
Section 1.1.4 Power and Lamp Requirements.
2-1