Safety Warnings And Guidelines; General Precautions; Ac/Power Precautions - Christie CP2000-M User Manual

5 Maintenance
Installers, service trained operators and all other users must maintain a safe operating environment at
all times. Read through this section in its entirety and understand all warnings and precautions before
attempting to operate the projector.
5.1

Safety Warnings and Guidelines

5.1.1 General Precautions

The extremely high brightness can cause permanent eye damage. For protection from
ultraviolet radiation, keep all projector housings intact during operation. Protective
safety clothing and safety goggles are recommended when servicing.
from the concentrated light beam of the lamp. Position all cables where they cannot
contact hot surfaces or be pulled or tripped over.
NOTES: 1) The American Conference of Governmental Industrial Hygienists (ACGIH) recommends
occupational UV exposure for an 8-hour day to be less than 0.1 microwatts per square centimeters of
effective UV radiation. An evaluation of your workplace is advised to assure employees are not
exposed to cumulative radiation levels exceeding the government guidelines for your area. 2) Be
aware that some medications are known to increase sensitivity to UV radiation.
This projector must be operated in an environment that meets the operating range specification, as
listed in Section 7

5.1.2 AC/Power Precautions

AC supply and cord are not within the specified voltage and power range. For details,
Section 7
refer to
three-wire plug with a third (grounding) pin. If you are unable to insert the plug into
the outlet, contact an electrician to have the outlet replaced. DO NOT defeat the
safety purpose of the grounding-type plug. DO NOT attempt operation if the AC
supply is not within the rated voltage range, as specified on the license label. Refer to
the license label on the back of the projector and to
3-3.
Use a suitable line cord that meets the appropriate rating standards. Only use attachments or
accessories recommended by Christie, such as the specific power cord supplied. Use of other
attachments or accessories with this projector may result in the risk of fire, shock or personal injury.
• DO NOT allow anything to rest on the power cord. Position the projector in a location where no
persons or objects can abuse the cord.
• Operate the projector at the specified voltage only.
• Overloaded power outlets and extension cords can result in fire or shock hazards.
CP2000-M/MR User Manual
020-100123-07 Rev. 1 (12-2009)
UV HAZARD: Never look directly into the projector lens or at the lamp.
FIRE HAZARD: Keep hands, clothes and all combustible material away
Specifications.
Use only the AC power cord supplied. DO NOT attempt operation if the
Specifications. As a safety feature the projector is equipped with a
3.2 Powering Up the Projector, on page
5-1