Site Requirements; Safety Warnings And Guidelines; Ac/Power Precautions; General Precautions - Christie H Series Service Manual

Site requirements

Notice. Failure to comply with the following may result in property damage.
• Replacement of optical light engine parts must be done in a clean room.

Safety warnings and guidelines

Warning! Failure to comply with the following could result in death or serious injury.
• NON-INSULATED DANGEROUS VOLTAGES MAY BE EXPOSED! Always power down and
• CHRISTIE ACCREDITED SERVICE TECHNICIANS REQUIRED! All module replacement
• ALLOW LAMP AND PROJECTOR TO COOL DOWN! Once you have turned off the projector,
Notice. Failure to comply with the following may result in property damage.
OBSERVE ALL ELECTROSTATIC PRECAUTIONS! Use a grounded wrist strap when handling
electronic assemblies.

AC/Power precautions

Warning! Failure to comply with the following could result in death or serious injury.
• Use only Christie approved power cords. Do not attempt operation if the AC supply and
• The projector is equipped with a three-wire plug with a grounding pin. This is a safety
• Do not allow anything to rest on the power cord. Locate the power cord where persons

General precautions

Warning! Failure to comply with the following could result in death or serious injury.
• Do not operate the projector with any internal parts removed. If for testing purposes, you
• HIGH BRIGHTNESS. Never look directly into the projector lens. The extreme high
• FIRE HAZARD. Keep hands, clothes and all combustible material away from the
H Series Service Manual
020-000802-03 Rev. 1 (12-2016)
disconnect/disengage all power sources to the projector before servicing or cleaning.
procedures must be performed by qualified service technicians.
allow the cooling fans to automatically turn off before disconnecting from AC and opening
the projector. This takes approximately 15 minutes.
cord are not within the specified voltage and power range. Refer to the license label on
the back of the projector for rated voltage and power.
feature. If you are unable to insert the plug into the outlet, contact an electrician to have
the outlet replaced. NEVER defeat the safety purpose of the grounding-type plug.
walking on it or objects rolling over it cannot damage the cord.
must operate the projector without the lid and/or lamp door, make sure to wear UV
glasses and stand well back from the projector at all times.
brightness can cause permanent eye damage.
concentrated light beam of the projector. Position all cables where they cannot contact hot
surfaces or become entangled or tripped over.
Introduction
5