The Lcp Display - Danfoss VLT AQUA Drive FC 200 Programming Manual

How to Program

2.2.1 The LCP Display

2 2
The LCP display has back light and a total of 6 alpha-
numeric lines. The display lines show the direction of
rotation (arrow), the chosen set-up as well as the
programming set-up. The display is divided into three
sections.
Top section shows up to two measurements in normal
operating status.
The top line in the Middle section shows up to five
measurements with related unit, regardless of status
(except in the case of alarm/warning).
Bottom section always shows the state of the adjustable
frequency drive in status mode.
Top section
Middle section
Bottom section
Figure 2.2
The Active set-up (selected as the Active Set-up in
0-10 Active Set-up) is shown. When programming another
set-up than the Active Set-up, the number of the
programmed set-up appears to the right.
Display Contrast Adjustment
Press [Status] and [
Press [Status] and [
Most parameter set-ups can be changed immediately via
the LCP, unless a password has been created via 0-60 Main
Menu Password or via 0-65 Personal Menu Password.
LEDs
If certain threshold values are exceeded, the alarm and/or
warning LED lights up. A status and alarm text appear on
the LCP.
The ON LED is activated when the adjustable frequency
drive receives line voltage, or via a DC bus terminal or 24
V external supply. At the same time, the backlight is on.
2-2
VLT
Status
43 RPM 5.44 A 25.3 kW
1.4 Hz
2.9%
! Pwr.card temp (W29)
Auto Remote Running
▲
] for darker display
▼
] for brighter display
MG20O622 - VLT
®
AQUA Drive Programming Guide
•
Green LED/On: Control section is working.
•
Yellow LED/Warn.: Indicates a warning.
•
Flashing Red LED/Alarm: Indicates an alarm.
Figure 2.3
LCP Keys
The control keys are divided into functions. The keys
below the display and LEDs are used for parameter set-up,
including choice of display indication during normal
operation:
! 1(1)
Status
Figure 2.4
[Status] indicates the status of the adjustable frequency
drive and/or the motor. Choose between three different
readouts by pressing [Status]: 5 line readouts, 4 line
readouts or Smart Logic Control.
Press [Status] to select Display mode or for changing back
to Display mode from either Quick Menu mode, Main
Menu mode or Alarm mode. Also press [Status] to toggle
single or double readout mode.
[Quick Menu]
Allows quick set-up of the adjustable frequency drive. The
most common functions can be programmed here.
The [Quick Menu] consists of:
- Q1: My Personal Menu
- Q2: Quick Setup
- Q3: Function Set-ups
- Q5: Changes Made
- Q6: Loggings
®
is a registered Danfoss trademark
On
Warn.
Alarm
Quick Main Alarm
Menu Menu Log