Readout And Programming Of Indexed Parameters; How To Program On The Numerical Lcp - Danfoss VLT AQUA Drive FC 200 Programming Manual

How to Program
2.2.15 Readout and Programming of
2 2
Indexed Parameters
Parameters are indexed when placed in a rolling stack.
15-30 Alarm Log: Error Code to 15-32 Alarm Log: Time
contain a fault log which can be read out. Choose a
parameter, press [OK], and use [
value log.
Use 3-10 Preset Reference as another example:
Choose the parameter, press [OK], and use [
through the indexed values. To change the parameter
value, select the indexed value and press [OK]. Change the
value by pressing [
setting. Press [Cancel] to abort. Press [Back] to leave the
parameter.

2.3 How to Program on the Numerical LCP

The following instructions are valid for the Numerical LCP
(LCP 101).
The control panel is divided into four functional groups:
1. Numerical display.
2. Menu keys and LEDs - changing parameters and
switching between display functions.
3. Navigation keys and LEDs (LEDs).
4. Operation keys and LEDs.
Display line: Status messages displaying icons and numeric
value.
Indicator lights (LEDs)
•
Green LED/On: Indicates if control section is on.
•
Yellow LED/Wrn.: Indicates a warning.
•
Flashing red LED/Alarm: Indicates an alarm.
LCP keys
[Menu] Select one of the following modes:
•
Status
•
Quick Set-up
•
Main Menu
2-10
®
VLT
▲ ▼
] [ ] to scroll through the
▲ ▼
] [
▲ ▼
] [ ]. Press [OK] to accept the new
MG20O622 - VLT
AQUA Drive Programming Guide
1
] to scroll
2
Menu
On
3
Warn.
Alarm
Hand
4
on
Figure 2.17
Status Mode
Displays the status of the adjustable frequency drive or the
motor.
If an alarm occurs, the NLCP automatically switches to
status mode.
A number of alarms can be displayed.
NOTICE!
Parameter copy is not possible with LCP 101 Numerical
Local Control Panel.
Figure 2.18
®
is a registered Danfoss trademark
Setup
Status Quick Main
Setup Menu
OK
Auto
O Reset
on
22.8
rpm
Setup 1