Danfoss VLT AQUA Drive FC 200 Programming Manual page 192

Parameter Description
29-21 Derag Power[HP]
Range:
0 hp [0 - 0 hp] Readout of calculated derag power at actual
*
3 3
29-22 Derag Power Factor
Range:
200 %
*
29-23 Derag Power Delay
Range:
601 s [1 - 601 s] The time that the adjustable frequency drive
*
29-24 Low Speed [RPM]
Range:
Size related
*
29-28 RPM]
29-25 Low Speed [Hz]
Range:
Size related
*
29-29 Hz]
29-26 Low Speed Power [kW]
Range:
Size related
*
29-27 Low Speed Power [HP]
Range:
Size related
*
29-28 High Speed [RPM]
Range:
Size related
*
par. 4-13 RPM]
29-29 High Speed [Hz]
Range:
Size related
*
par. 4-14 Hz]
3-166
Function:
speed.
Function:
[1 - 400 %]
Function:
must remain on reference and a high power
condition for a derag to occur.
Function:
[ par. 4-11 - par. Set output speed used for
registration of derag power at
low speed in RPM.
Function:
[ par. 4-12 - par. Set output speed used for
registration of derag power at
low speed in Hz.
Function:
[ 0 - 0.00 kW] Set derag power at low speed in
kW.
Function:
[ 0 - 0.00 hp] Set derag power at low speed in
hp.
Function:
[ par. 29-24 - Set output speed used for
registration of derag power at
high speed in RPM.
Function:
[ par. 29-25 - Set output speed used for
registration of derag power at
high speed in Hz.
MG20O622 - VLT
®
VLT AQUA Drive Programming Guide
29-30 High Speed Power [kW]
Range:
Size related
29-31 High Speed Power [HP]
Range:
Size related
29-32 Derag On Ref Bandwidth
Range:
5 %
*
29-33 Power Derag Limit
Range:
3 [0–10] The number of times the power monitor can trigger
*
29-34 Consecutive Derag Interval
Range:
Size related
®
is a registered Danfoss trademark
Function:
[ 0 - 0.00 kW] Set derag power at high speed in
*
kW.
Function:
[ 0 - 0.00 hp] Set derag power at high speed in
*
hp.
[1 - 100 %]
Function:
consecutive derags before a fault is reported.
Function:
[Size related] The time for an additional power
*
derag to be considered
"consecutive".
Function: