Danfoss VLT AQUA Drive FC 200 Programming Manual page 127

Parameter Description
16-64 Analog Input 54
Range: Function:
0 [-20 - 20 ] View the actual value at input 54.
*
16-65 Analog Output 42 [mA]
Range: Function:
0 [0 - 30 ] View the actual value at output 42 in mA. The
*
value shown reflects the selection in 6-50 Terminal
42 Output.
16-66 Digital Output [bin]
Range: Function:
0 [0 - 15 ] View the binary value of all digital outputs.
*
16-67 Pulse Input #29 [Hz]
Range: Function:
0 [0 - 130000 ] View the actual frequency rate on terminal
*
29.
16-68 Pulse Input #33 [Hz]
Range: Function:
0 [0 - 130000 ] View the actual frequency rate on terminal
*
33.
16-69 Pulse Output #27 [Hz]
Range: Function:
0 [0 - 40000 ] View the actual value on terminal 27 in digital
*
output mode.
16-70 Pulse Output #29 [Hz]
Range: Function:
0 [0 - 40000 ] View the actual value of pulses on terminal 29
*
in digital output mode.
16-71 Relay Output [bin]
Range: Function:
0 [0 - 511 ] View the settings of all relays.
*
Figure 3.44
®
VLT AQUA Drive Programming Guide
0
0
0
0
0
3.15.5 16-8* Fieldbus & FC Port
Parameters for reporting the BUS references and control
words.
0
®
MG20O622 - VLT is a registered Danfoss trademark
16-72 Counter A
Range: Function:
[-2147483648 - View the present value of Counter A.
*
2147483647 ] Counters are useful as comparator
operands, see 13-10 Comparator Operand.
The value can be reset or changed either
via digital inputs (parameter group 5-1*)
or by using an SLC action (13-52 SL
Controller Action).
16-73 Counter B
Range: Function:
[-2147483648 - View the present value of Counter B.
*
2147483647 ] Counters are useful as comparator
operands (13-10 Comparator Operand).
The value can be reset or changed either
via digital inputs (parameter group 5-1*)
or by using an SLC action (13-52 SL
Controller Action).
16-75 Analog In X30/11
Range: Function:
[-20 - 20 ] View the actual value at input X30/11 of MCB
*
101.
16-76 Analog In X30/12
Range: Function:
[-20 - 20 ] View the actual value at input X30/12 of MCB
*
101.
16-77 Analog Out X30/8 [mA]
Range: Function:
[0 - 30 ] View the actual value at input X30/8 in mA.
*
16-80 Fieldbus CTW 1
Range: Function:
[0 - View the two-byte control word (CTW)
*
65535 ] received from the bus master. Interpretation of
the control word depends on the serial
communication option installed and the
control word profile selected in 8-10 Control
Profile.
For more information, refer to the relevant
serial communication bus manual.
3 3
3-101