Danfoss VLT AQUA Drive FC 200 Programming Manual page 13

Introduction
Input polarity of control terminals
PNP (Source)
Digital input wiring
12 13 18 19 27
Figure 1.3
NPN (Sink)
Digital input wiring
12 13 18 19 27
Figure 1.4
NOTICE!
Control cables must be shielded/armored.
See section on grounding of shielded/armored control
®
cables in the VLT AQUA Drive Design Guide, MG20N for the
correct termination of control cables.
®
VLT AQUA Drive Programming Guide
29 32 33 20 37
29 32 33 20 37
®
MG20O622 - VLT is a registered Danfoss trademark
Figure 1.5
1.1.6 Start/Stop
Terminal 18 = 5-10 Terminal 18 Digital Input [8] Start
Terminal 27 = 5-12 Terminal 27 Digital Input [0] No
operation (Default coast inverse)
Terminal 37 = Safe stop (where available)
Figure 1.6
1 1
1-7