Danfoss VLT AQUA Drive FC 200 Programming Manual page 165

Parameter Description
A Maintenance Log with the latest 10 loggings can be read from parameter group 18-0* and via the Alarm log key on the
LCP after selecting Maintenance Log.
NOTICE!
The Preventive Maintenance Events are defined in a 20 element array. Hence each Preventive Maintenance Event must use
the same array element index in 23-10 Maintenance Item to 23-14 Maintenance Date and Time.
23-10 Maintenance Item
Array [20]
Option:
Array with 20 elements displayed
below parameter number in the
display. Press [OK] and step
between elements with [◄], [►],
[
Select the item to be associated
with the preventive maintenance
event.
[1] Motor bearings
[2] Fan bearings
[3] Pump bearings
[4] Valve
[5] Pressure transmitter
[6] Flow transmitter
[7] Temperature transmitter
[8] Pump seals
[9] Fan belt
[10] Filter
[11] Drive cooling fan
[12] System health check
[13] Warranty
[20] Maintenance Text 0
[21] Maintenance Text 1
[22] Maintenance Text 2
[23] Maintenance Text 3
[24] Maintenance Text 4
[25] Maintenance Text 5
23-11 Maintenance Action
Array [20]
Option: Function:
Select the action to be associated with
the preventive maintenance event.
[1] Lubricate
[2] Clean
[3] Replace
[4] Inspect/Check
[5] Overhaul
[6] Renew
[7] Check
[20] Maintenance Text 0
®
VLT AQUA Drive Programming Guide
Function:
▲ ▼
] and [ ].
®
MG20O622 - VLT is a registered Danfoss trademark
23-11 Maintenance Action
Array [20]
Option: Function:
[21] Maintenance Text 1
[22] Maintenance Text 2
[23] Maintenance Text 3
[24] Maintenance Text 4
[25] Maintenance Text 5
23-12 Maintenance Time Base
Array [20]
Option: Function:
Select the time base to be associated with the
Preventive Maintenance Event.
[0] Disabled [0] Disabled must be used when disabling the
Preventive Maintenance Event.
[1] Running [1] Running Hours is the number of hours the
Hours motor has been running. Running hours are
not reset at power-on. The Maintenance Time
Interval must be specified in
23-13 Maintenance Time Interval.
[2] Operating [2] Operating Hours is the number of hours the
Hours adjustable frequency drive has been running.
Operating hours are not reset at power-on.
The Maintenance Time Interval must be
specified in 23-13 Maintenance Time Interval.
[3] Date & Time [3] Date & Time uses the internal clock. The
date and time of the next maintenance
occurrence must be specified in
23-14 Maintenance Date and Time.
3 3
3-139