Danfoss VLT AQUA Drive FC 200 Programming Manual page 77

Parameter Description
5-40 Function Relay
Option:
[160] No alarm
[161] Running reverse
[165] Local ref active
[166] Remote ref active
[167] Start command activ
[168] Hand mode
[169] Auto mode
[180] Clock Fault
[181] Prev. Maintenance
[188] AHF Capacitor Connect
[189] External Fan Control
[190] No-Flow
[191] Dry Pump
[192] End Of Curve
[193] Sleep Mode
[194] Broken Belt
[195] Bypass Valve Control
[198] Drive Bypass
[199] Pipe Filling
[211] Cascade Pump 1
[212] Cascade Pump 2
[213] Cascade Pump 3
[214] Cascade Pump 4
[215] Cascade Pump 5
[216] Cascade Pump 6
[217] Cascade Pump 7
[218] Cascade Pump 8
[219] Cascade Pump 9
[230] Ext. Cascade Ctrl
5-41 On Delay, Relay
Array [9], (Relay 1 [0], Relay 2 [1], Relay 3 [2], Relay 4 [3], Relay 5
[4], Relay 6 [5], Relay 7 [6], Relay 8 [7], Relay 9 [8])
Range: Function:
0.01 s [0.01 - 600 s] Enter the delay of the relay cut-in time.
*
Select one of available mechanical relays
and MCB 105 in an array function. See
5-40 Function Relay. Relay 3-6 are
included in MCB 113.
®
VLT AQUA Drive Programming Guide
Function:
®
MG20O622 - VLT is a registered Danfoss trademark
Selected
Event
Relay
output
On Delay
P 5-41
Selected
Event
Relay
output
On Delay
P 5-41
Figure 3.24
5-42 Off Delay, Relay
Array[2]: Relay1[0], Relay2[1]
Range: Function:
0.01 s [0.01 - 600 s] Enter the delay of the relay cut-out time.
*
Select one of available mechanical relays
and MCB 105 in an array function. See
5-40 Function Relay.
Selected
Event
Relay
output
On Delay
P 5-41
Figure 3.25
If the selected event condition changes before the on or
off delay timer expires, the relay output is unaffected.
3.7.5 5-5* Pulse Input
The pulse input parameters are used to define an
appropriate window for the impulse reference area by
configuring the scaling and filter settings for the pulse
inputs. Input terminals 29 or 33 act as frequency reference
inputs. Set terminal 29 (5-13 Terminal 29 Digital Input) or
terminal 33 (5-15 Terminal 33 Digital Input) to [32] Pulse
input. If terminal 29 is used as an input, then set
5-02 Terminal 29 Mode to [0] Input.
O Delay
P 5-42
O Delay
P 5-42
3-51
3 3