Parameter Description; Parameter Selection - Danfoss VLT AQUA Drive FC 200 Programming Manual

Parameter Description

3 Parameter Description

3.1 Parameter Selection

The parameters are grouped into various parameter groups for easy selection of the correct parameter for optimized
adjustable frequency drive operation.
Overview of parameter groups
Group Title
0-** Operation/Display
1-** Load/Motor
2-** Brakes
3-** Reference/Ramps
4-** Limits/Warnings
5-** Digital In/Out
6-** Analog In/Out
8-** Communication and Options
9-** Profibus
10-** DeviceNet Ser ComBus
13-** Smart Logic
14-** Special Functions
15-** Drive Information
16-** Data Readouts
18-** Info and Readouts
20-** Drive Closed-loop
21-** Extended Closed-loop
22-** Application Functions
23-** Time-based Functions
24-** Application Functions 2
25-** Basic Cascade Controller Functions
26-** Analog I/0 Option MCB 109
27-** Extended Cascade Control
29-** Water Application Functions
30-** Special Features
31-** Bypass Option
35-** Sensor Input Option
Table 3.1 Parameter Groups
®
VLT AQUA Drive Programming Guide
Function
Parameters related to the fundamental functions of the adjustable frequency drive,
function of the LCP keys and configuration of the LCP display.
Parameter group for motor settings.
Parameter group for setting brake features in the adjustable frequency drive.
Parameters for reference handling, defining limitations, and configuring the
reaction of the adjustable frequency drive to changes.
Parameter group for configuring limits and warnings.
Parameter group for configuring the digital inputs and outputs.
Parameter group for configuring the analog inputs and outputs.
Parameter group for configuring communications and options.
Parameter group for Profibus-specific parameters (requires profibus option).
Parameter group for DeviceNet-specific parameters (requires DeviceNet option).
Parameter group for Smart Logic Control
Parameter group for configuring special adjustable frequency drive functions.
Parameter group containing adjustable frequency drive information such as
operating data, hardware configuration and software versions.
Parameter group for data readouts, such as current references, voltages, control,
alarm, warning and status words.
This parameter group contains the last 10 Preventive Maintenance logs.
This parameter group is used for configuring the closed-loop PID controller that
controls the output frequency of the unit.
Parameters for configuring the three extended closed-loop PID controllers.
These parameters monitor water applications.
These parameters are for actions to be performed on a daily or weekly basis, such
as different references for working hours/non-working hours.
Parameters for the Drive Bypass.
Parameters for configuring the Basic Cascade Controller for sequence control of
multiple pumps.
Parameters for configuring the Analog I/0 Option MCB 109.
Parameters for configuring the Extended Cascade Control (MCO 101/MCO 102).
Parameters for setting water specific functions.
Parameters for configuring the brake resistor value.
Parameters for configuring the Bypass Option (MCO 104).
Parameters for configuring the Sensor Input Option (MCB 114)
®
MG20O622 - VLT is a registered Danfoss trademark
3 3
3-1