Danfoss VLT AQUA Drive FC 200 Programming Manual page 93

Parameter Description
8-82 Slave Messages Rcvd
Range: Function:
0 [0 - 0 ] This parameter shows the number of valid
*
telegrams addressed to the slave, sent by the
adjustable frequency drive.
8-83 Slave Error Count
Range: Function:
0 [0 - 0 ] This parameter shows the number of error
*
telegrams, which could not be executed by the
adjustable frequency drive.
3.9.7 8-9* Bus Jog
8-90 Bus Jog 1 Speed
Range: Function:
100 RPM [ 0 - par. 4-13 Enter the jog speed. Activate this
*
RPM] fixed jog speed via the serial port
or serial communication option.
8-91 Bus Jog 2 Speed
Range: Function:
200 RPM [ 0 - par. 4-13 Enter the jog speed. Activate this
*
RPM] fixed jog speed via the serial port
or serial communication option.
8-94 Bus Feedback 1
Range: Function:
0 [-200 - Write a feedback to this parameter via the serial
*
200 ] communication port or serial communication
option. This parameter must be selected in
20-00 Feedback 1 Source, 20-03 Feedback 2
Source or 20-06 Feedback 3 Source as a feedback
source.
8-95 Bus Feedback 2
Range: Function:
0 [-200 - 200 ] See 8-94 Bus Feedback 1 for further details.
*
8-96 Bus Feedback 3
Range: Function:
0 [-200 - 200 ] See 8-94 Bus Feedback 1 for further details.
*
®
VLT AQUA Drive Programming Guide
®
MG20O622 - VLT is a registered Danfoss trademark
3 3
3-67