Table B-11. Analog Current Output Range Values - Thermo Scientific 5028i Instruction Manual

I/O Configuration
Thermo Fisher Scientific
section of the "Operation" chapter for more information.
Send: tz
Receive: tz EST+5EDT
set tz string
This command sets the timezone string for the instrument for use with
the NTP server, where string is a standard timezone string. Common
strings are listed in the "Timezone" screen description in Chapter 3.
Send: set tz EST+5EDT
Receive: set tz EST+5EDT ok
analog iout range channel
This command reports the analog current output range setting for
channel, where channel must be between 1 and 6, inclusive. The
following example reports current output channel 4 is in the 4-20 mA
range, according to Table
not enabled" if the I/O expansion board is not detected.
Send: analog iout range 4
Receive: analog iout range 4 2
set analog iout range channel range
This command sets analog current output channel to the range where
channel is between 1 and 6 inclusive, and range is set according to
B–11. The following example sets current output channel 4 to the 0-20
mA range. This command responds with "feature not enabled" if the I/
O expansion board is not detected.
Send: set analog iout range 4 1
Receive: set analog iout range 4 1 ok
Table B–11. Analog Current Output Range Values
Range
1
2
0 [cannot be set to this, but may report]
analog vin channel
This command retrieves the analog voltage input channel data, both the
calculated value and the actual voltage. In the following example, the
"calculated" value of channel 1 is 75.325 degrees F, volts are 2.796. This
command responds with "feature not enabled" if the I/O expansion
board is not detected.
B–11. This command responds with "feature
Output Range
0-20 mA
4-20 mA
Undefined
Model 5028i Instruction Manual
C-Link Protocol Commands
I/O Configuration
Table
B-55