Thermo Scientific 5028i Instruction Manual page 289

Thermo Fisher Scientific
Send: set addr dns 192.168.1.1
Receive: set addr dns 192.168.1.1 ok
addr gw
This command reports the default TCP/IP gateway address.
Send: addr gw
Receive: addr gw 192.168.1.1
set addr gw address
This command sets the default gateway address, where address consists of
four numbers ranging from 0-255 inclusive, separated by ".".
Note This command cannot be used when DHCP is on. Refer to the
DHCP command that follows for additional information.
Send: set addr gw 192.168.1.1
Receive: set addr gw 192.168.1.1 ok
addr ip
This command reports the IP address of the analyzer.
Send: addr ip
Receive: addr ip 192.168.1.200
set addr ip address
This command sets the analyzer's IP address, where address consists of
four numbers ranging from 0-255 inclusive, separated by ".".
Note This command cannot be used when DHCP is on. Refer to the
DHCP command that follows for additional information.
Send: set addr ip 192.168.1.200
Receive: set addr ip 192.168.1.200 ok
addr nm
This command reports the IP netmask.
Send: addr nm
Receive: addr nm 255.255.252.0
set addr nm mask
This command sets the netmask mask, where mask consists of four
numbers ranging from 0-255 inclusive, separated by ".".
Note This command cannot be used when DHCP is on. Refer to the
DHCP command that follows for additional information.
C-Link Protocol Commands
Communications Configuration
s
s
s
Model 5028i Instruction Manual B-49