Restore Default Calibration; Flow Calibration; Auto Flow Calibration - Thermo Scientific 5028i Instruction Manual

Restore Default Calibration

RESTORE DEFAULT CAL:
RANGE

Flow Calibration

Auto Flow Calibration

Thermo Fisher Scientific
The Restore Default Calibration screen allows the user to reset the
default values.
Note Be sure to close the toggle switch after calibration is complete.
In the Main Menu, choose Service > Pres/Vacuum Calibration >
l
Vac/Flow or Vac/Flow B > Set Defaults.
RESTORE
AVG DIAGS ALARM
The Flow Calibration submenu is used to view and set the flow
calibration flow point. The flow calibration screen is visible only when
the instrument is in service mode. For more information on the service
mode, see
Note Flow Span B settings please refer to Flow Span as following
description.
Note This adjustment should only be performed by an instrument
service technician.
In the Main Menu, choose Service > Flow Calibration>Flow Span
l
or Flow Span B.
The Auto Flow Calibration screen allows the user to view and set the
correct flow rate. The span value is automatically calculated.
In the Main Menu, choose Service > Flow Calibration > Flow Span
l
or Flow Span B>Auto.
RESTORE DEFAULT CAL:
ARE YOU SURE YOU WANT
PRESS
RANGE
"Service Mode" earlier in the chapter.
s
s
FLOW CALIBRATION:
>AUTO
MANUAL
RANGE AVG
RESTORE
TO CONFIRM RESTORE
AVG DIAGS ALARM
DIAGS ALARM
Model 5028i Instruction Manual
Operation
Service Menu
s
TO?x
3-75