Thermo Scientific 5028i Instruction Manual page 85

Flag Status Data
Communication Settings
Serial Settings
Thermo Fisher Scientific
The Flag Status Data screen is used to set the flag status data to either
ON or OFF for the selected record type.
In the Main Menu, choose Instrument Controls > Datalogging
l
Settings > Configure Datalogging > Flag Status Data.
The Communication Settings menu is used for communications control
and configuration.
In the Main Menu, choose Instrument Controls > Communication
l
Settings.
The Serial Setting submenu is used for serial communications control
and configuration.
In the Main Menu, choose Instrument Controls > Communication
l
Settings > Serial Settings.
Baud Rate The Baud Rate screen is used to set the RS-232/RS-485 interface baud
rate. Baud rates of 1200, 2400, 4800, 9600, 19200, 38400, 57600, and
115200 are available. The analyzer's default baud rate is set to 9600 to
provide backwards compatibility with the older C-series analyzers.
In the Main Menu, choose Instrument Controls > Communication
l
Settings > Serial Settings > Baud Rate.
SET LREC FLAG STATUS DATA:
CURRENTLY: OFF
SET TO: ON
CHANGE VALUE
RANGE AVG DIAGS ALARM
COMMUNICATION SETTINGS:
>SERIAL SETTINGS
INSTRUMENT ID
GESYTEC SERIAL NO
COMMUNICATION PROTOCOL
STREAMING DATA CONFIG
TCP/IP SETTINGS
RANGE AVG DIAGS ALARM
SERIAL SETTINGS:
>BAUD RATE
DATA BITS
PARITY
STOP BITS
RS-232/485 SEL
RANGE AVG DIAGS ALARM
Operation
Instrument Controls Menu
?
SAVE
9600
8
NONE
1
RS-232
Model 5028i Instruction Manual 3-31