Table B-1. Error Response Messages; Table B-2. C-Link Protocol Commands - Thermo Scientific 5028i Instruction Manual

Commands List
Thermo Fisher Scientific
Table B–1. Error Response Messages
Command Response
bad cmd
too high
too low
invalid string
data not valid
can't, wrong settings
can't, mode is service
feature not enabled
flags no alarm active
The "save" and "set save params" commands (duplicated for backward
compatibility) store parameters in FLASH memory. It is important that
this command be sent each time instrument parameters are changed. If
changes are not saved, they will be lost in the event of a power failure.
Table B–2 lists the 5028i C-Link protocol commands. The interface will
respond to the command strings outlined below.
Table B–2. C-Link Protocol Commands
Command Description
addr dns Reports/sets domain name server address for Ethernet port
addr gw Reports/sets default gateway address for Ethernet port
addr ip Reports/sets IP address for Ethernet port
addr nm Reports/sets netmask address for Ethernet port
addr ntp Reports/sets IP address for network time protocol server
alarm alpha Reports/sets alpha count alarm maximum value
count max a/b
alarm alpha Reports/sets alpha count alarm minimum value
count min a/b
alarm amb rh Reports/sets ambient relative humidity alarm maximum value B-12
max
alarm amb rh Reports/sets ambient relative humidity alarm minimum value B-12
min
alarm amb temp Reports/sets ambient temperature alarm maximum value
max
alarm amb temp Reports/sets ambient temperature alarm minimum value
min
Description
Command is not recognized
Supplied value is higher than the upper limit
Supplied value is lower than the lower limit
Supplied string invalid (typically because a letter was detected
when the value should be numeric)
Supplied value is not acceptable for entered command
Command not allowed for current measurement mode
Command not allowed while instrument is in service mode
I/O expansion board is not detected
No measurement alarms are active
C-Link Protocol Commands
Commands
B-48
B-49
B-49
B-49
B-50
B-11
B-11
B-12
B-12
Model 5028i Instruction Manual
Page
B-3