Thermo Fisher Scientific
pres comp
This command reports whether pressure compensation is for actual
or standard conditions. The following example shows the pressure
compensation is standard.
Send:
pres comp
Receive:
pres comp std
set pres comp selection
selection = | act | std |
These commands turn the pressure compensation to either actual
or standard conditions. The following example turns the pressure
compensation to actual.
Send:
set pres comp act
Receive:
set pres comp act ok
pres std a/b
This command reports the standard pressure. The following example
reports that the standard pressure is 760 mmHg.
Send:
pres std a
Receive:
pres std a 760 mmHg
Send:
pres std b
Receive:
pres std b 760 mmHg
set pres std a/b value
This command sets the standard pressure to value, where value is a
floating-point number representation of standard pressure between 0 to
760 mmHg. The following example sets the standard pressure to 730
mmHg.
Send:
set pres std a 730
Receive:
set pres std a 730 ok
Send:
set pres std b 730
Receive:
set pres std b 730 ok
range a/b
This command reports the current PM range. If the mode is incorrect,
the instrument responds with "can't, wrong settings". The following
example reports that the PM range is set to 5 mg/m
B–5.
Send:
range a
Receive:
range a 4: (5.000E+00 mg/m3)
Send:
range b
Receive:
range b 4: (5.000E+00 mg/m3)
C-Link Protocol Commands
Measurement Configuration
3
, according to
Model 5028i Instruction Manual
Table
B-43